Danfoss VLT FC 280 Operating Manual page 91

Operating Guide | VLT® Midi Drive FC 280
Table 40: LCP Copy Messages
(continued)
Message
Status
!1(1)
0 RPM None 0.00KW
SO Custom. completed
SO RESET required!
!Safe Stop [W68]
Off Remote SO Req.RESET
Status
!1(1)
0 RPM None 0.00KW
SO Custom. aborted
SO RESET required!
!Safe Stop [W68]
Off Remote SO Req.RESET
Table 41: Mismatch Between Safety Parameters in the Safety Option and in the Drive
Message
0 RPM 0.00 A
!1(1)
SO Param. Selection
Mismatch of SO param.set
detected. Please choose:
SO : Test1234_ 1.00
VLT : SafeSet1_ 1.00
Status
!1(1)
0 RPM None 0.00KW
SO Custom. completed
SO RESET required!
!Safe Stop [W68]
Off Remote SO Req.RESET
0 RPM None
1(1)
Safety Password
Please enter the safety
Password
0 0000000
0 RPM None
1(1)
Pa
0-
Password accepted
[0
([1] Enabled)
0 RPM None
1(1)
Pa
0-
Password rejected
[0
([1] Enabled)
Danfoss A/S © 2024.10
Description
Press [OK] to complete the customization of the safety option. A reset is required to finalize
this procedure.
Press [Cancel] to abort the customization of the safety option. A reset is required to finalize this
procedure.
Description
Whenever there is a mismatch of safety parameters within the safety option and the drive, this
selection form is shown on the LCP. Select between the Safety data on safe option or the Safety
data on drive valid data.
If selecting [SO:...], the customization of the safety option is completed and a reset is required
to finalize this procedure.
If selecting [VLT:...] and the password protection in parameter 0-69 Password Protection of
Safety Parameters is enabled, enter the correct LCP-copy/parameter mismatch password
(parameter 0-68 Safety Parameters Password).
If the entered password is correct, this overlay message is shown for some seconds.
If the entered password is wrong, this overlay message is shown for some seconds. Then the
password can be entered again.
Safety Functions
AQ381425076031en-000201 / 130R1223 | 91