Using Issu To Upgrade The Subpackages In A Dual Route Processor Configuration - Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router Software Configuration Manual

ISSU Upgrade for Redundant Platforms
*Jul 21 23:54:27.271: %REDUNDANCY-3-STANDBY_LOST: Standby processor fault
(PEER_REDUNDANCY_STATE_CHANGE)
*Jul 21 23:57:05.528: %ASR1000_OIR-6-ONLINECARD: Card (rp) online in slot R0
*Jul 21 23:57:25.480: %REDUNDANCY-5-PEER_MONITOR_EVENT: Active detected a standby
insertion (raw-event=PEER_FOUND(4))
*Jul 21 23:57:25.480: %REDUNDANCY-5-PEER_MONITOR_EVENT: Active detected a standby
insertion (raw-event=PEER_REDUNDANCY_STATE_CHANGE(5))
*Jul 21 23:58:47.172: %HA_CONFIG_SYNC-6-BULK_CFGSYNC_SUCCEED: Bulk Sync succeeded
*Jul 21 23:58:47.173: %RF-5-RF_TERMINAL_STATE: Terminal state reached for (SSO)

Using ISSU to Upgrade the SubPackages in a Dual Route Processor Configuration

This section provides instructions on performing an ISSU upgrade on a Cisco ASR 1000 Series Router
with dual RPs that is currently running individual subpackages.
This section covers the following topics:
•
•
Using ISSU to Upgrade the SubPackages on a Cisco ASR 1006 or ASR 1013 Router (issu Command Set)
This section provides the instructions for performing an ISSU upgrade using subpackages on a Cisco
ASR 1006 router or ASR 1013 router with a dual RP setup using the issu command set.
This procedure can only be performed if the current ASR 1006 or ASR 1013 routers have two active RPs
and both RPs are running subpackages.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
4-12
Using ISSU to Upgrade the SubPackages on a Cisco ASR 1006 or ASR 1013 Router (issu Command
Set), page 4-12
Using ISSU to Upgrade SubPackages on a Cisco ASR 1006 Router or ASR 1013 Router (request
platform command set), page 4-45
show version
show version active-rp installed
dir filesystem:<directory>
show platform
show redundancy-states
copy running-config startup-config
mkdir URL-to-directory-name
ip tftp source-interface gigabitethernet slot/port
copy tftp: URL-to-target-location
request platform software package expand file URL-to-consolidated-package
dir URL-to-consolidated-package
copy file-system:asr1000rp1-espbase.version.pkg URL-to-directory-of-sub-packages-active-RP
copy file-system:asr1000rp1-rpaccess.version.pkg URL-to-directory-of-sub-packages-active-RP
copy file-system:asr1000rp1-rpbase.version.pkg URL-to-directory-of-sub-packages-active-RP
copy file-system:asr1000rp1-rpcontrol.version.pkg URL-to-directory-of-sub-packages-active-RP
Chapter 4 Software Upgrade Process
OL-16506-10