Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router Software Configuration Manual page 145

Chapter 4 Software Upgrade Process
Command or Action
Step 15
issu loadversion rp 0 file
file-system
:asr1001-{rpbase,sipbase,sipspa,espbase}*
ersion
*.pkg force
Example:
Router#issu loadversion rp 0 file
bootflash:221subs/asr1001-{rpbase,sipbase,sipspa,es
pbase}*03.02.01.S.151-1.S1_2.pkg force
Step 16
show version installed
Example:
Router# show version installed
Step 17
reload
Example:
Router# reload
Examples
The following example shows the software upgrade for Cisco ASR 1001 Router running subpackages.
Router#show version
Cisco IOS Software, IOS-XE Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Experimental
Version 15.1(20110301:124851) [asr1001-universalk9.03.02.01.S.151-1.S1]
Copyright (c) 1986-2011 by Cisco Systems, Inc.
Compiled Tue 01-Mar-11 06:25 by mcpre
Cisco IOS-XE software, Copyright (c) 2005-2011 by cisco Systems, Inc.
All rights reserved.
licensed under the GNU General Public License ("GPL") Version 2.0.
software code licensed under GPL Version 2.0 is free software that comes
with ABSOLUTELY NO WARRANTY.
GPL code under the terms of GPL Version 2.0.
documentation or "License Notice" file accompanying the IOS-XE software,
or the applicable URL provided on the flyer accompanying the IOS-XE
software.
OL-16506-10
Upgrade Process With Service Impact for Nonredundant Platforms
Purpose
Upgrade the RP, SIP, SPA, and ESP subpackages for
v
each SIP on the router.
Note
Tip
Note
(Optional) Verify that the subpackages are properly
installed.
(Optional) Reload the RP.
Tip
Certain components of Cisco IOS-XE software are
You can redistribute and/or modify such
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
This step must be completed one SIP at a time,
and repeated for each SIP installed on the router
before performing the next step.
You can use the show ip interface brief
command to identify which slots contain SIPs
and SPAs. The interfaces with three numbers (in
the form
SIP-number/SPA-number/interface-number)
identify the SIP and SPA locations in the router.
The pattern options used in this CLI (rpbase,
sipbase, sipspa, and espbase) were introduced
in Cisco IOS XE Release 2.1.2 and are not
available in previous Cisco IOS XE Releases.
See the "ISSU Procedures (Prior to Cisco IOS
XE Release 2.1.2)" section on page 4-73
pre-Cisco IOS XE Release 2.1.2 ISSU upgrade
procedures.
The router will continue normal operation even
without a reload, so you can reload the router
during scheduled maintenance or a slower
traffic period. It is highly recommended reload
to avoid conflicts in the software base.
The
For more details, see the
for
4-83