Configuration - Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router Software Configuration Manual

ISSU Upgrade for Redundant Platforms
Command or Action
Step 7
telnet ip-address port
Example:
[unix-server-1 ~]$ telnet 172.17.52.157 2003
User Access Verification
Username: user
Password: ********
Router>
Step 8
issu acceptversion
Example:
Router# issu acceptversion
Step 9
issu commitversion
Example:
Router# issu commitversion
Step 10
show version
show version active-RP running
show version active-RP provisioned
show platform
show running-configuration
Step 11
hw-module slot RP-slot reload
Example:
Router# hw-module slot R0 reload
Examples
The following example shows how to perfrom consolidated package upgrade in a dual route processor

configuration:

Router(config)# ip tftp source-interface gigabitethernet 0
Router# copy tftp bootflash:
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
4-8
Chapter 4
Purpose
Log in to the RP being upgraded, preferably using
the RP's console port, to complete the upgrade. (This
is the new active RP, that was the standby RP prior to
the ISSU process.)
Ensure the hostname does not end in "-stby"
Note
after logging into the RP, as this indicates
that the RP being accessed is still the standby
RP.
There are many ways to log on to a console port. The
example shows access to the console port from a
UNIX host using telnet.
(Optional) Stops the ISSU rollback timer.
This step is optional as long as
before the rollback timer expires.
Completes the ISSU upgrade.
(Optional) Enter the show version, show platform,
or show runnning-configuration commands to
confirm that the upgrade completed successfully, as
follows:
show version—Confirm that the correct
•
software version is running on your router and
that the RP was booted from the correct file.
show running-configuration—Confirm that
•
the booting configuration, in particular the boot
system statements, are correct.
Use the show running-config | include boot
Tip
command to display only the boot statements
from the show running-configuration
output.
show platform— Confirm that both RP0 and
•
RP1 are correctly running as active and standby.
Reload the new software on the Standby RP.
Software Upgrade Process
Step 9 is completed
OL-16506-10