Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router Software Configuration Manual page 35

Chapter 2 Using Cisco IOS XE Software
Table 2-5
Table 2-5 Finding Command Options
Command
Router> enable
Password: <password>
Router#
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
Router(config)# interface serial ?
<0-6> Serial interface number
Router(config)# interface serial 4 ?
/
Router(config)# interface serial 4/ ?
<0-3> Serial interface number
Router(config)# interface serial 4/0 ?
<cr>
Router(config)# interface serial 4/0
Router(config-if)#
OL-16506-10
shows examples of how you can use the question mark (?) to assist you in entering commands.
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Comment
Enter the enable command and password to access
privileged EXEC commands. You are in privileged
EXEC mode when the prompt changes to a "
the " "; for example,
> Router> to Router#
Enter the configure terminal privileged EXEC
command to enter global configuration mode. You
are in global configuration mode when the prompt
changes to
Router(config)#
Enter interface configuration mode by specifying
the serial interface that you want to configure using
the interface serial global configuration command.
Enter ? to display what you must enter next on the
command line. In this example, you must enter the
serial interface slot number and port number,
separated by a forward slash.
When the <cr> symbol is displayed, you can press
Enter to complete the command.
You are in interface configuration mode when the
prompt changes to
Router(config-if)#.
Getting Help
" from
#
.
.
2-9