Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router Software Configuration Manual page 320

Configuring a Bridge Domain Interface
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Router# configure terminal
Step 2
interface BDI{interface number}
Example:
Router(config)# interface BDI3
Step 3
ip address ip-address mask
or
ipv6 address {X:X:X:X::X link-local |
X:X:X:X::X/prefix [anycast | eui-64] |
autoconfig [default]}
Example:
Router(config-if)# ip address 2.2.2.1
255.255.255.0
Step 4
mac-address {mac-address}
Router(config-if)#mac-address 1.1.3
Step 5
no shut
Example:
hostname(config-if)# no shut
Step 6
shut
Example:
hostname(config-if)# shut
Example
The following example shows the configuration of a bridge domain interface at IP address 2.2.2.1
255.255.255.0:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# interface BDI3
Router(config-if)# ip address 2.2.2.1 255.255.255.0
Router(config-if)# mac-address 1.1.3
Router(config-if)# no shut
Router(config-if)# exit
Router(config)#
You can use different show commands to display the bridge domain interface configuration information:
•
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
11-6
show interfaces—Displays the configuration summary of the bridge domain interface.
Example:
Router# show interfaces BDI3
Chapter 11
Purpose
Enters the global configuration mode.
Specifies the bridge domain interface on a Cisco ASR 1000
Series Router.
Specifies either the IPv4 or IPv6 address for the bridge
domain interface.
Specifies the MAC address for the bridge domain interface.
Enables the bridge domain interface on the Cisco ASR 1000
Series Router.
Disables the bridge domain interface on the Cisco ASR
1000 Series Router.
Configuring Bridge Domain Interfaces
OL-16506-10