Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router Software Configuration Manual page 69

Chapter 4 Software Upgrade Process
Command or Action
URL-to-target-location
Step 2
copy tftp:
source-file-system
copy
standby-destination-filesystem
Example:
Router# copy tftp bootflash:
source-file-system
Step 3
copy
standby-destination-filesystem
Example:
Router# copy
bootflash:asr1000rp1-adventerprisek9.02.01.01.122-33.
XNA1.bin stby-bootflash:
URL-to-target-location
Step 4
dir
URL-to-target-stby-location
dir
Example:
Router# dir bootflash:
Router# dir stby-bootflash:
Step 5
issu loadversion rp
standby-file-system
Example:
Router# issu loadversion rp 1 file
stby-bootflash:asr1000rp1-adventerprisek9.02.01.01.12
2-33.XNA1.bin
Step 6
issu runversion
Example:
Router# issu runversion
OL-16506-10
filename
:
filename
:
upgrade-rp-number
filename
:
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
ISSU Upgrade for Redundant Platforms
Purpose
Copy the consolidated package onto the active RP.
Copy the consolidated package onto the standby RP.
(Optional) Display the contents of the target
directories to confirm the successful copy of the file
package.
Load the target consolidated package onto the
standby RP.
After you receive the message indicating that the
terminal state has been reached, go on to
Run the consolidated package that was loaded in
Step 5.
If this command is entered before the
Note
terminal state is reached, a "
" or "
online Standby RP is not in
" error message will be seen
terminal state
and the issu runversion command will not
work. If the issu runversion command does
not run for these reasons, wait for the
"
terminal state is reached
appear and retry the issu runversion
command. You can also monitor the terminal
state using the show platform command.
After ISSU runversion is completed, a switchover
will automatically occur and the standby RP will
become the active RP.
Step 6.
peer is not
" message to
4-7