Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router Software Configuration Manual page 224

How to Configure Call Home
7.
8.
9.
10.
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Router# configure terminal
Step 2
call-home
Example:
Router(config)# call-home
Step 3
profile name
Example:
Router(config-call-home)# profile profile1
Step 4
destination transport-method email
Example:
Router(cfg-call-home-profile)# destination
transport-method email
Step 5
destination address email email-address
Example:
Router(cfg-call-home-profile)# destination
address email myaddress@example.com
Step 6
destination preferred-msg-format {long-text |
short-text | xml}
Example:
Router(cfg-call-home-profile)# destination
preferred-msg-format xml
Step 7
destination message-size bytes
Example:
Router(cfg-call-home-profile)# destination
message-size 3145728
Step 8
active
Example:
Router(cfg-call-home-profile)# active
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
7-8
destination message-size bytes
active
exit
end
Purpose
Enters global configuration mode.
Enters call home configuration mode.
Enters call home destination profile configuration mode for
the specified destination profile name. If the specified
destination profile does not exist, it is created.
(Optional) Configures the message transport method for
email. This is the default.
(Required) Configures the destination e-mail address to
which Call Home messages are sent.
(Optional) Configures a preferred message format. The
default is XML.
(Optional) Configures a maximum destination message size
(from 50 to 3145728 bytes) for the destination profile. The
default is 3145728 bytes.
(Optional) Enables the destination profile. By default, a
user-defined profile is enabled when it is created.
Chapter 7 Configuring Call Home
OL-16506-10