Configuring Clock Recovery From A Bits Port - Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router Software Configuration Manual

Chapter 10 Synchronous Ethernet Support

Configuring Clock Recovery from a BITS Port

This section describes how to configure clock recovery from BITS port.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
DETAILED STEPS
Command
Step 1
enable
Example:
Router# enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
network-clock synchronization automatic
Example:
Router(config)# network-clock
synchronization automatic
Step 4
network-clock synchronization ssm
option {option_id {GEN1 | GEN2}}
Example:
Router(config)# network-clock
synchronization ssm option 2 GEN1
OL-16506-10
enable
configure terminal
network-clock synchronization automatic
network-clock synchronization ssm option option_Id Generation_Id
network-clock input-source priority {interface interface_name slot/card/port | {external
slot/card/port }}
exit
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Configuring Synchronous Ethernet
Purpose
Enables the privileged EXEC mode.
Enter your password if prompted.
Enters the global configuration mode.
Enables the network clock selection algorithm. This
command disables the Cisco-specific network clock
process, and turns on the G.781-based automatic clock
selection process.
Configures the equipment to work in synchronization
network. The option_id value 1 refers to synchronization
networks design for Europe. This is the default value. The
option_id value 2 refers to the synchronization networks
design for the U.S.
10-7