Working With Destination Profiles - Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router Software Configuration Manual

How to Configure Call Home
Command or Action
Step 9
exit
Example:
Router(cfg-call-home-profile)# exit
Step 10
end
Example:
Router(cfg-call-home)# end
Configuring a Trustpoint Certificate Authority
If you are using the HTTP transport method and specifying an HTTPS destination URL, then you will
also need to configure a trustpoint certificate authority (CA).
For more information about how to configure a trustpoint CA, see the
Trustpoint" section on page
Cisco server to use with the Smart Call Home service, but can be applied to other secure server
configuration as needed by your site using the required certificate for your secure server.

Working With Destination Profiles

This section describes some of the tasks that you can complete with destination profiles:
•
•
•
•
Activating and Deactivating a Destination Profile
Except for the predefined CiscoTAC-1 profile, all Call Home destination profiles are automatically
activated once you create them. If you do not want to use a profile right way, you can deactivate the
profile. The CiscoTAC-1 profile is inactive by default and must be activated to be used.
To activate or deactivate a destination profile, complete the following steps:
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
7-12
7-28. That section describes how to configure a CA trustpoint for a secure
Activating and Deactivating a Destination Profile, page 7-12
Copying a Destination Profile, page 7-13
Renaming a Destination Profile, page 7-14
Using the Predefined CiscoTAC-1 Destination Profile, page 7-15
configure terminal
call-home
profile name
active
no active
end
Purpose
Exits call home destination profile configuration mode and
returns to call home configuration mode.
Returns to privileged EXEC mode.
Chapter 7 Configuring Call Home
"Declare and Authenticate a CA
OL-16506-10