Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router Software Configuration Manual page 314

Configuring Synchronous Ethernet
Table 10-3
Problem
Incorrect QL values
when you use the show
network-clock
synchronization detail
command.
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
10-18
Troubleshooting Scenarios (continued)
Solution
Reproduce the current issue and collect the logs using the debug
•
network-clock errors, debug network-clock event, and debug
network-clock sm RP commands.
Warning
Note
Use the network clock synchronization SSM (option 1 |option 2)
•
command to confirm that there is no framing mismatch. Use the show
run interface command to validate the framing for a specific interface.
For the SSM option 1, framing should be SDH or E1, and for SSM option
2, it should be T1.
Reproduce the issue using the debug network-clock errors and debug
•
network-clock event RP commands or enable the debug hw-module
subslot command. (This is specific to SIP-400).
Warning
Chapter 10
We suggest you do not use these debug commands
without TAC supervision.
Contact Cisco Technical Support if the issue persists.
We suggest you do not use these debug commands
without TAC supervision.
Synchronous Ethernet Support
OL-16506-10