Verifying The Synce Configuration - Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router Software Configuration Manual

Chapter 10 Synchronous Ethernet Support

Verifying the SyncE Configuration

Use the following commands to verify the SyncE configuration:
•
•
OL-16506-10
Use the show network-clock synchronization command to display the output:
Router#show network-clock synchronization
Symbols: En - Enable, Dis - Disable, Adis - Admin Disable
NA - Not Applicable
* - Synchronization source selected
# - Synchronization source force selected
& - Synchronization source manually switched
Automatic selection process : Enable
Equipment Clock : 1544 (EEC-Option2)
Clock Mode : QL-Enable
ESMC : Enabled
SSM Option : GEN1
T0 : External R0 t1 esf
Hold-off (global) : 300 ms
Wait-to-restore (global) : 300 sec
Tsm Delay : 180 ms
Revertive : No
Force Switch: FALSE
Manual Switch: FALSE
Number of synchronization sources: 2
sm(netsync NETCLK_QL_ENABLE), running yes, state 1A
Last transition recorded: (src_rem)-> 1A (src_added)-> 1A (src_rem)-> 1A (src_added)->
1A (ql_change)-> 1A (sf_change)-> 1A (force_sw)-> 1C (clear_sw)-> 1A (sf_change)-> 1A
(sf_change)-> 1A
Nominated Interfaces
Interface SigType
Internal NA
Gi1/2/0 NA
*External R0 T1 ESF
Use the show network-clock synchronization detail command to display all the details of network
clock synchronization parameters at the global and interface levels as shown in the following
example:
Router#show network-clock synchronization detail
Symbols: En - Enable, Dis - Disable, Adis - Admin Disable
NA - Not Applicable
* - Synchronization source selected
# - Synchronization source force selected
& - Synchronization source manually switched
Automatic selection process : Enable
Equipment Clock : 1544 (EEC-Option2)
Clock Mode : QL-Enable
ESMC : Enabled
SSM Option : GEN1
T0 : External R0 t1 esf
Hold-off (global) : 300 ms
Wait-to-restore (global) : 300 sec
Tsm Delay : 180 ms
Revertive : No
Force Switch: FALSE
Manual Switch: FALSE
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Mode/QL Prio QL_IN
NA/Dis 251 QL-ST3
Sync/En 1 QL-FAILED -
NA/En 2 QL-STU
Configuring Synchronous Ethernet
ESMC Tx ESMC Rx
NA NA
-
NA NA
10-13