Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router Software Configuration Manual page 183

Chapter 4 Software Upgrade Process
DETAILED STEPS
Command or Action
Step 1
show version
show version installed
filesystem
dir :<
show platform
show redundancy-states
Example:
Router# show version
Router# show version r0 installed
Router# dir bootflash:
Router# show platform
Router# show redundancy-states
Step 2
redundancy
mode sso
Example:
Router(config)# redundancy
Router(config-red)# mode sso
URL-to-directory-name
Step 3
mkdir
Example:
Router# mkdir usb0:221subs
source-interface gigabitethernet slot/port
Step 4
ip tftp
Example:
Router(config)# ip tftp source-interface
gigabitethernet 0
URL-to-target-location
Step 5
copy tftp:
Example:
Router# copy tftp: usb0:221subs
OL-16506-10
directory
>
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Upgrade Process With Service Impact for Nonredundant Platforms
Purpose
(Optional) Use the following commands to confirm the
current router configuration, as follows:
• show version and show version active-rp
installed—Verify the running version of the Cisco IOS
XE software on the router, and which file was used to
boot the router, and where that file is stored.
dir—Confirm that the files that were used to boot the
•
router are located in the directory.
show platform—Confirm the current status of the
•
active and standby RPs.
show redundancy states—Confirm the operational
•
and configured redundancy states.
Configure SSO if it is not already configured.
Save the configuration after making this
Note
configuration step.
Create a directory to store the consolidated package and
subpackages.
This directory must be created in most cases because the
consolidated packages and subpackages have to be
separated from the subpackages that booted the router at
this step of the procedure.
Specifies the Gigabit Ethernet TFTP source-interface to be
configured:
slot/port—Specifies the location of the TFTP
source-interface.
To copy a file using TFTP through the Management
Note
Ethernet interface, the ip tftp source-interface
GigabitEthernet 0 command must be entered
before entering the copy tftp command.
Copy the consolidated package file into the directory
created in Step 3.
The consolidated package in this step should not be copied
into the same directory where the subpackages that are
currently running your router are stored (the directory
containing the packages.conf provisioning file from which
the router was booted).
It is recommended that you copy the package onto
Tip
a usb: or harddisk: file system for space
considerations when performing this step of the
procedure.
4-121