Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router Software Configuration Manual page 68

ISSU Upgrade for Redundant Platforms
This procedure will only work if the current RPs are already running consolidated packages.
Note
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
DETAILED STEPS
Command or Action
source-interface gigabitethernet slot/port
Step 1
ip tftp
Example:
Router(config)# ip tftp source-interface
gigabitethernet 0
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
4-6
ip tftp source-interface gigabitethernet slot/port
copy tftp: URL-to-target-location
copy source-file-system:filename standby-destination-filesystem
dir URL-to-target-location
dir URL-to-target-stby-location
issu loadversion rp upgrade-rp-number standby-file-system:filename
issu runversion
telnet ip-address port
issu acceptversion
issu commitversion
show version, show version active-RP running, show version active-RP provisioned
show platform
show running-configuration
hw-module slot RP slot number reload
Chapter 4
Purpose
Specifies the Gigabit Ethernet TFTP
source-interface to be configured:
slot/port—Specifies the location of the TFTP
source-interface.
To copy a file using TFTP through the
Note
Management Ethernet interface, the ip tftp
source-interface GigabitEthernet 0
command must be entered before entering
the copy tftp command.
Software Upgrade Process
OL-16506-10