Configuring Persistent Ssh - Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router Software Configuration Manual

Configuring Persistent SSH

Configuring Persistent SSH
This task describes how to configure persistent SSH on the Cisco ASR 1000 Series Routers.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
transport-map type persistent ssh
transport-map-name
Example:
Router(config)# transport-map type persistent
ssh sshhandler
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
8-8
(Required) enable
(Required) configure terminal
(Required) transport-map type persistent ssh transport-map-name
(Required) connection wait [allow {interruptible} | none {disconnect}]
(Required) rsa keypair-name rsa-keypair-name
(Optional) authentication-retries number-of-retries
(Optional) banner [diagnostic | wait] banner-message
(Optional) time-out timeout-interval-in-seconds
(Required) transport interface GigabitEthernet 0
(Required) exit
(Required) transport type persistent ssh input transport-map-name
Chapter 8
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
Creates and names a transport map for handling persistent
SSH connections, and enters transport map configuration
mode.
Console Port, Telnet, and SSH Handling
OL-16506-10