Cisco ASR1000-RP1 - ASR 1000 Series Route Processor 1 Router Software Configuration Manual page 225

Chapter 7 Configuring Call Home
Command or Action
Step 9
exit
Example:
Router(cfg-call-home-profile)# exit
Step 10
end
Example:
Router(cfg-call-home)# end
Configuring Other Email Options
For the e-mail transport method, you can also configure the from and reply-to e-mail addresses by
completing the following steps:
SUMMARY STEPS
1.
2.
3.
4.
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Router# configure terminal
Step 2
call-home
Example:
Router(config)# call-home
Step 3
sender from email-address
Example:
Router(cfg-call-home)# sender from
username@example.com
Step 4
sender reply-to email-address
Example:
Router(cfg-call-home)# sender reply-to
username@example.com
OL-16506-10
configure terminal
call-home
sender from email-address
sender reply-to email-address
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Purpose
Exits call home destination profile configuration mode and
returns to call home configuration mode.
Returns to privileged EXEC mode.
Purpose
Enters global configuration mode.
Enters call home configuration mode.
(Optional) Assigns the e-mail address that will appear in the
from field in Call Home e-mail messages. If no address is
specified, the contact e-mail address is used.
(Optional) Assigns the e-mail address that will appear in the
reply-to field in Call Home e-mail messages.
How to Configure Call Home
7-9