Ip Igmp Filter - Cisco catalyst 3750 Command Reference Manual

ip igmp filter

ip igmp filter
Use the ip igmp filter interface configuration command to control whether or not all hosts on a Layer 2
interface can join one or more IP multicast groups by applying an Internet Group Management Protocol
(IGMP) profile to the interface. Use the no form of this command to remove the specified profile from
the interface.
Syntax Description profile number
Defaults
No IGMP filters are applied.
Command Modes Interface configuration
Command History Release
12.1(11)AX
Usage Guidelines
You can apply IGMP filters only to Layer 2 physical interfaces; you cannot apply IGMP filters to routed
ports, switch virtual interfaces (SVIs), or ports that belong to an EtherChannel group.
An IGMP profile can be applied to one or more switch port interfaces, but one port can have only one
profile applied to it.
Examples
This example shows how to apply IGMP profile 22 to a port:
Switch(config)# interface gigabitethernet1/0/2
Switch(config-if)# ip igmp filter 22
You can verify your setting by using the show running-config privileged EXEC command and by
specifying an interface.
Catalyst 3750 Switch Command Reference
2-238
ip igmp filter profile number
no ip igmp filter
The IGMP profile number to be applied. The range is 1 to 4294967295.
Modification
This command was introduced.
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
OL-8552-07