Configuring The Storm Suppression Ratio For An Ethernet Interface - 3Com MSR 50 Series Configuration Manual

n
Configuring the Storm
Suppression Ratio for an
Ethernet Interface
add ports to or removing ports from a link aggregation port group can only be
achieved through operations on the link aggregation group.
Manual port group is mainly used to synchronize the configurations among the
ports in it. When you use the display current-configuration or display this
command to view the current configuration, the configuration concerning manual
port group is not displayed. The configuration of manual port group gets invalid
after you reboot the device even if you have saved the current configuration
before reboot.
Aggregation port group is mainly used to achieve the port aggregation function.
You can use the display current-configuration or display this command to
view aggregation port group-related information. In addition, if you save the
configuration concerning aggregation port group, it remains valid even if you
reboot the device.
Follow these steps to enter aggregation port group view:
To do...
Enter system view
Enter port group Enter manual port group view
view
Enter aggregation port group
view
Follow these steps to configure a manual port group:
To do...
Enter system view
Create a manual port group and
enter port group view
Add Ethernet interfaces to the
manual port group
Refer to "Aggregation Port Group" on page 349
aggregation port group.
You can use the following commands to suppress the broadcast, multicast, and
unknown unicast traffic. When the broadcast, multicast, or unknown unicast
traffic over the interface exceeds the threshold, the system will discard the extra
packets so that the broadcast, multicast, or unknown unicast traffic ratio can drop
below the limit to ensure that the network functions properly.
Follow these steps to configure a storm suppression ratio for an Ethernet interface
To do...
Enter system view
Configuring Layer 2 Ethernet Interfaces
Use the
command...
system-view
port-group
manual
port-group-name
port-group
aggregation
agg-id
Use the command...
system-view
port-group aggregation agg-id Required
group-member interface-list
for the information about
To use...
system-view
Remarks
-
-
Remarks
-
Required
Remarks
-
93