Configuring Frame Relay Address Mapping; Configuring Frame Relay Local Virtual Circuit; Configuring Frame Relay Switching; Configuring Frame Relay Subinterface - 3Com MSR 50 Series Configuration Manual

246 C 8: F
HAPTER RAME
Configuring Frame Relay
Address Mapping
Configuring Frame Relay
Local Virtual Circuit
Configuring Frame Relay
Switching
Configuring Frame Relay
Subinterface
Configuring Frame Relay
over IP Network

Configuring Annex G

Displaying and
Maintaining Frame
Relay
R C
ELAY ONFIGURATION
To do...
Configure frame relay
interface type to DCE or NNI
Configure frame relay LMI
protocol type
Configure network side N392 fr lmi n392dce n392-value
Configure network side N393 fr lmi n393dce n393-value
Configure network side T392
Refer to "Configuring Frame Relay Address Mapping" on page
Refer to "Configuring Frame Relay Local Virtual Circuit" on page
Refer to "Configuring Frame Relay Switching" on page
Refer to "Configuring Frame Relay Subinterface" on page
Refer to "Configuring Frame Relay over IP Network" on page
Refer to "Configuring Annex G" on page
To do...
Display frame relay
protocol status on
interface
Display mapping table
of protocol address and
frame relay address
Use the command...
fr interface-type { dce | nni } Required
fr lmi type { ansi |
nonstandard | q933a }
fr lmi t392dce t392-value
244.
Use the command...
display fr interface
[ interface-type
{ interface-number |
interface-number.subnumber }
]
display fr map-info
[ interface interface-type
{ interface-number |
interface-number.subnumber }
]
Remarks
The default frame relay
interface type is DTE.
Optional
The default frame relay LMI
protocol type is q933a.
Optional
The default value is 3.
Optional
The default value is 4.
Optional
The default value is 15
seconds.
239.
239.
240.
241.
242.
Remarks
Available in any view
Either all the information or the
information of specified interfaces
can be shown. The specified
interface can be either main
interface or subinterface.
Available in any view
Either all the information or the
information of specified interfaces
can be shown. The specified
interface can be either main
interface or subinterface.