Connecting Power; Power Over Ethernet (Poe) From The Lan - 3Com AirProtect Sentry 5850 Quick Start Manual

The figures below show a cable being routed through the large opening in the cradle and
then the cradle being mounted to a wall.
3
Connect the Ethernet cable (for power and network connection) to the port on the rear of
the Sentry.
4
Twist the Sentry onto the mounting bracket.
Tabletop Mounting
To install the Sentry on a flat surface such as a table or desktop:
1
Remove the backing from the four rubber feet and attach them on the bottom of the Sentry.
2
Place the Sentry on the table.
3
Connect the Ethernet cable (for power and network) to the port on the rear of the Sentry.

5. Connecting Power

The Sentry can be powered by the following methods:
•
By Power Over Ethernet (PoE) supplied over the LAN by a 802.3af PoE compliant device such
as a switch or hub.
•
By PoE supplied by a PoE injector (not included).

Power Over Ethernet (PoE) from the LAN

To power the Sentry using PoE provided by a switch or other 802.3af compliant device, simply
plug the network cable from the device into the Sentry's Ethernet port.
Sentry
Routing a cable Wall-mounting the cradle
PoE Switch/Hub
6