Dcc For Dialup Isdn Bri Line And Leased Line Connection - 3Com MSR 50 Series Configuration Manual

3com msr 30-16: software guide
Hide thumbs Also See for MSR 50 Series:
Table of Contents

Advertisement

192
C
6: DCC C
HAPTER
ONFIGURATION
[RouterA-Bri1/1] link-protocol ppp
[RouterA-Bri1/1] ppp authentication-mode pap
[RouterA-Bri1/1] ppp pap local-user usera password simple usera
# Configure PPP authentication on BRI 1/0 and assign it to dialer bundle 1.
[RouterA-Bri1/0] interface bri 1/0
[RouterA-Bri1/0] dialer bundle-member 1
[RouterA-Bri1/0] ppp mp
[RouterA-Bri1/0] link-protocol ppp
[RouterA-Bri1/0] ppp authentication-mode pap
[RouterA-Bri1/0] ppp pap local-user usera password simple usera
2 Configure Router B
# Configure a dial access control rule for dialer access group 2; create a local user
account usera for Router A and configure PPP authentication for it; and set traffic
statistics interval to three seconds for DCC.
<RouterB> system-view
[RouterB] dialer-rule 2 ip permit
[RouterB] local-user usera
[RouterB-luser-usera] password simple usera
[RouterB-luser-usera] service-type ppp
[RouterB-luser-usera] quit
[RouterB] dialer flow-interval 3
# Assign an IP address to interface Dialer0; enable C-DCC; and configure the dial
strings, MP, and information for PPP authentication.
[RouterB] interface dialer 0
[RouterB-Dialer0] ip address 100.1.1.2 255.255.255.0
[RouterB-Dialer0] dialer enable-circular
[RouterB-Dialer0] dialer-group 2
[RouterB-Dialer0] dialer route ip 100.1.1.1 8810048
[RouterB-Dialer0] dialer route ip 100.1.1.1 8810049
[RouterB-Dialer0] ppp mp
[RouterB-Dialer0] ppp authentication-mode pap
[RouterB-Dialer0] ppp pap local-user userb password simple userb
[RouterB-Dialer0] quit
# Configure CE1/PRI interface E1 2/0 and set it to work in PRI mode.
[RouterB] controller e1 2/0
[RouterB-E1 2/0] pri-set
[RouterB-E1-2/0] quit
# Enable C-DCC on interface Serial 2/0:15 created on interface E1 2/0 and assign
the serial interface to interface Dialer 0.
[RouterB] interface serial 2/0:15
[RouterB-Serial2/0:15] dialer enable-circular
[RouterB-Serial2/0:15] dialer circular-group 0
DCC for Dialup ISDN BRI
Network requirements
Line and Leased Line
Figure 27
presents a scenario where:
Connection

Hide quick links:

Advertisement

Table of Contents

Troubleshooting

loading
Need help?

Need help?

Do you have a question about the MSR 50 Series and is the answer not in the manual?

Questions and answers

Table of Contents