Configuring Atm; Configuring Atm Interface; Configuring An Atm Sub-Interface; Checking Existence Of Pvcs When Determining The Protocol State Of An Atm P2P - 3Com MSR 50 Series Configuration Manual

130 C 5: ATM C
HAPTER

Configuring ATM

Configuring ATM
Interface
Configuring an ATM
Sub-Interface
Configuring an ATM
Sub-Interface
ONFIGURATION
Complete these tasks to configure ATM:
Task
"Configuring ATM Interface" on page 130

"Configuring an ATM Sub-Interface"

on page 130
"Configuring PVC" on page 131
"Configuring an ATM Class" on page 133
"Configuring VP Policing" on page 136
"Configuring Applications over
ATM" on page 136
Depending on the actual networking environment and system requirements,
sometimes it may be necessary to modify certain parameters of an ATM interface.
Note that although these parameters apply to the ATM main interface and
sub-interfaces at the same time, they must be modified in ATM main interface
view, except for the mtu command, which can be executed on a sub-interface.
Refer to "ATM and DSL Interface Configuration" on page 71
about ATM interface configuration.
Follow these steps to configure an ATM sub-interface:
To do...
Enter system view
Create an ATM sub-interface
and enter its view
"Configuring an ATM
Sub-Interface" on page
130
"Checking Existence of
PVCs When Determining
the Protocol State of an
ATM P2P Sub-interface"
on page 131
"Configuring PVC
parameters" on page 131
"Assigning a Transmission
Priority to an ATM PVC"
on page 132
"Configuring PVC Service
Map" on page 133
"Configuring IPoA" on
page 136
"Configuring IPoEoA" on
page 137
"Configuring PPPoA" on
page 137
"Configuring PPPoEoA"
on page 138
Use the command...
system-view
interface atm
interface-number.subnumber
[ p2mp | p2p ]
Remarks
Required
Required
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
for more information
Remarks
-
Required
By default, the type of a
sub-interface is
point-to-multipoint (p2mp).