FP PostBase Vision M2 Reference Manual page 19

Installation and commissioning
Connectivity settings
Default settings for an Ethernet connection
are stored for connecting to the FP infrastruc-
ture. Establishing the connection should run
seamlessly with these settings.
To test the connection to the FP infrastruc-
ture with this default setting:
• Tap the 'Continue' button.
If no connection is established, the 'Connec-
tivity Settings' must be adjusted:
• Tap 'Change' to open the wizard for setting
up the network connection.
• First select the desired connection type.
• Confirm the selection and continue with the
'Continue' button.
• Set the appropriate parameters for the net-
work step by step. If necessary, ask your
network administrator.
The 'Connectivity Settings' overview shows
and explains the possible settings (see
page 84).
Caution! During the further course of instal-
lation, the PostBase Vision M2 may start up
multiple times. Do not disconnect the
PostBase Vision M2 from the power supply.
19