Control Console And Load Cell Cables; Mounting The Control Console; Connecting The Control Console Power Cable - Ametek Chatillon CS1100 User Manual

2.4 CONTROL CONSOLE AND LOAD CELL CABLES

NOTE: To maintain EMC compatibility, only connection leads
supplied by CHATILLON should be used to connect the control
console and load cell.

2.5 MOUNTING THE CONTROL CONSOLE

The control console is fitted with a rear mounted ball joint adapter. The force tester is
supplied with another ball joint adaptor fitted on the right hand side of the vertical column.
The control console is attached to the force tester using the supplied spring-loaded clamp.
Carefully place the control console face down on a bench or table. Squeeze the "spring" end
of the clamp and position the other end over the ball joint adapter on the rear of the console.
Ensure that the clamp is mounted over the left hand side of the control console, i.e. over the
power socket and Ethernet connection and also ensure that the handscrew mechanism is
towards the top of the control console.
Carefully lift the control console and position the free end of the spring clamp over the ball
joint adaptor on the vertical column. Once fitted, position the console where it can be easily
viewed and operated by the user. Once you have positioned the console, tighten the
handscrew so that the console is secured in the intended position. Ensure that the control
console does not move when pressing on the touch screen.
WARNING
Always support the control console whenever adjusting the spring loaded clamp. If
the control console falls from the mounting location, serious injury or damage to the
equipment can result

2.6 CONNECTING THE CONTROL CONSOLE POWER CABLE

The control console is powered using the supplied "plug top" power supply. Plug
this into the mains outlet on the rear of the machine then connect the circular
power supply plug to the DC input socket on the left hand side of the control
console.
CS User Manual 15