Advertisement
10) Look around the machine and check each part for oil leaks.
●If you can confirm an oil leak, please contact your dealer shop.
●Continued use with oil leakage is dangerous and may cause damage to the machine.
5.3.1 Wire / belt adjustment for each part
1) Before adjusting the belt /wire /rod, be sure to stop the engine on a wide flat surface,
remove the key, set the parking brake, and check the safety sufficiently.
2) To adjust the belt and Blade brake, open the seat bracket with your hand and pull it up,
and make sure the seat is upright. (If you lift it, it will be fixed in that position.)
3) Ask your dealer to replace the blade belt and drive belt. Special tools and techniques are
required to replace the belt.
Seat bracket
①Drive belt adjustment (bottom of engine)
The Driving belt is always in tension. If the belt slips while Driving, refer to the photo below.
Adjust the tension of the belt by changing the position of the tension spring. Normally, the
tension spring is hooked to the third hole from the rear side. When tensioning, hang it on the
second hole from the rear side. As a guide, the spring extension is 90 mm when the belt is
stretched normally (the free length of the spring is 80 mm).
Tension Spring
Rear side
Front side
- 44 -
5. 点検・整備・調整
Lift Up
about 90mm
Advertisement
