Adjusting Each Wire - OREC GRH537Pro Owner's Manual

5) Adjusting each wire

WARNING
Check that you are taking sufficient safety precautions when adjusting each type of wire by
●
placing the machine on a flat, open surface with the engine switched off and the spark plug cord
removed.
Please verify that the machine moves properly after the adjustment.
●
If operation does not improve after adjustment, please contact the dealer where you
●
purchased the machine.
■Blade control wire
LOCK
NUTS
(M6)
A
B
ADJUSTER
■Drive clutch wire
LOCK
NUTS
(M6)
A
B
ADJUSTER
■Throttle wire
LOCK
NUTS
(M6)
A
B
ADJUSTER
■ Speed change wire
LOCK
NUTS
(M6)
A
B
ADJUSTER
1.
2.
BLADE CONTROL
WIRE
1.
2.
DRIVE CLUTCH
WIRE
THROTTLE WIRE
1.
2.
SPEED CHANGE
WIRE
1.
2.
27
Push the Blade safety lock and then pull
back the Blade control lever (pg. 20).
If the spring that connects the blade control wire
and the Blade control lever does not extend:
Move the Adjuster towards [B]
If the spring that connects the Blade control
wire and the Blade control lever is not slack:
Move the Adjuster towards [A]
Push the Driving clutch lever forward, hold
with the handle and then pull the machine
back. Make sure the wheels are locked.
If the wheels do not lock when you pull the lever,
or unlock when stress is put on the machine:
Move the Adjuster towards [B]
If the wheels lock even when you release the drive
clutch lever or the unit does not stop properly:
Move the Adjuster towards [A]
Slide the Throttle lever up to the choke
position and then back to the [HI] position.
If it does NOT push the choke arm enough:
Move the Adjuster towards [B]
If it pushes the Choke arm while in the [HI]
position:
Move the Adjuster towards [A]
Make sure the wheels are locked when you
hold the handle with Driving clutch lever at
each speed position.
If the wheels do not lock on 3rd speed(gear)
the speed is slow even at maximum speed(hst):
Move the Adjuster towards [B]
If the wheels do not lock on 1st speed or the
change lever cannot be moved to 3rd speed(gear)
you are traveling at a minimum speed(hst):
Move the Adjuster towards [A]