Table of Contents
Advertisement
How to Run the Machine
Initial inspection before running the machine
In order to safely operate the machine, please refer to the [Periodic voluntary inspection table] on page 39.
Please have any defective parts repaired immediately, before operating the machine again.
How to move the machine manually with the engine switched off
1.
Put the speed change lever in the [N] position.
2.
Grip the drive clutch lever [ON] and push the machine forward.
How to start and stop the engine
Do not start the engine in a confined space or a place with insufficient ventilation. Engine exhaust is
odorless and contains carbon monoxide which can cause death.
Absolutely do not handle gasoline in the presence of lit cigarettes, naked flame, or other sources of
ignition. Gasoline is an extremely flammable liquid and there is a danger of fires and explosions.
Ensure that the drive clutch and blade clutch are in the [OFF] position, the speed change lever is in the
[N] position, and the brake is ON, before starting the engine. Taking precautions when starting the
engine can prevent injury and accidents.
Fully read the caution and danger labels which have been attached to this machine.
Before starting the engine
Place the machine on a flat surface and perform the following procedures to check the quantity of engine oil
and fuel.
：Check engine oil
Prep 1
Make sure the engine has cooled down before checking oil. There is a danger of burns.
This machine is shipped WITHOUT ENGINE OIL. Fill with the engine oil to the correct level before starting
the engine, even if there are traces of residual oil in the engine from factory testing.
Inspect with the engine horizontal and do not screw in the dipstick.
Please use good quality, new engine oil of SD level or higher.
・ Engine oil: SAE10W-30 Transmission oil: SAE90 or SAE80W-90
（Please refer to the engine use manual）
16
Hide quick links:
Advertisement
Table of Contents
