Advertisement
4) When traveling on a river, cliff, or a step (road shoulder) to prevent falling, please
run on a sufficiently safe flat place.
5) It is dangerous to use it in poor visibility when it is dark. Please do not use when
place condition cannot be grasped sufficiently.
1) Do not use this machine in the rain or in a pool of water where it may be exposed to a large
amount of water.
2) Be aware to other climatic conditions, etc., and pay sufficient attention to work implementation
and selection of equipment.
1.2.２ Inspection before work
1) Operation with safety device and safety cover removed is dangerous, please check the normal
condition.
2) It is very dangerous to operate without the safety devices and related parts that are standard
equipment as well as safety covers. To prevent accidents, be sure to use these parts with them
attached. If there is any abnormality, repair it and check the normal condition before operating the
work.
3) When the work clutch (Blade clutch, etc.) is in the "disengaged" position, check that the V-belt is
securely stopped. If it is moving even a little, stop the engine, adjust the belt retainer, and adjust
the wire.
4) The falling off of the Blade is dangerous. Please tighten the set bolt and nut of the Blade securely.
Also, please replace the old one with a new one.
5) If there is an opening / closing cover for Blade replacement, it is dangerous to use while
keeping it open. Be sure to use it in a closed state.
6) Always check the effectiveness of the parking brake. Incorrect brake adjustment may cause a
serious accident. Please check with one or more of the following.
(1) When the Driving clutch lever is in the "off" position (the sub-change shift lever is in the "N"
position), the parking brake is applied and when push it with two adults do not move.
(2) Tires lock up during sudden braking while driving.
(3) The parking brake is working on the 2m bridge which hooked it on the bed of a light truck.
7) Before starting work, be sure to remove the cooling air intake of the engine, the clogging near the
cylinder, especially the high temperature around the exhaust pipe and the debris accumulated on
the machine. It may cause engine burn-in or fire.
Also, clean is not only the outside but also the inside of the air cleaner and the inside of the HST
fan cover (applicable product) at the same time.
- 5 -
1. ご使⽤の前に
Advertisement
