Table of Contents
Advertisement
TRAVEO™ T2G Cluster 4M Lite Kit user guide
KIT_T2G_C-2D-4M_LITE
System and functional description
Figure 5
Connecting Micro-B cable between X400 and USB port of laptop
Note:
In this option, the PSoC™ 5LP (KitProg3) is also powered up, which is not possible in other powering
options. If the KitProg3 mode status LED (D401) is glowing, then PSoC™ 5LP (KitProg3) is powered up.
2.3
Pre-programmed firmware
The TRAVEO™ T2G Cluster 4M Lite kit is tested and shipped with preloaded software and starts executing once
the kit is powered up. The kit has pre-programmed software with full test logs and FX3 IRIS pattern firmware.
After powering up the device and checking the initial jumper positions, refer to the procedure mentioned in the
following sections to see the full test log firmware and FX3 IRIS pattern firmware.
User guide
13
002-39200 Rev. **
2023-12-11
Advertisement
Table of Contents
