Table of Contents
Advertisement
TRAVEO™ T2G Cluster 4M Lite Kit user guide
KIT_T2G_C-2D-4M_LITE
Programming and debugging
8. Now click the "Go" icon to start the execution. You can also use the function keys in the Debug window: F5
(Go), F10 (Step Over), F11 (Step into), and Ctrl+D (Download and Debug).
Figure 46
Running the code in IAR workspace for TRAVEO™ T2G Cluster 4M Lite kit
9. In free-running execution, user LED1 (D900) starts blinking on the board.
4.3
Program and debug CYT3DL device using KitProg3
To program and debug this kit using KitProg3, connect the Micro-B cable between X400 and USB port of the PC.
After connecting the Micro-B cable, follow the same steps as mentioned in
identical, except the debugger option and connection, which will change.In the "debugger option", select "CMSIS
DAP" since it is supported by the KitProg3 USB-UART bridge to flash the code and debugging.
Figure 47
shows the connection of the Micro-B cable between jumper X400 and the USB port of the PC.
Figure 47
Connecting USB Micro-B cable between X400 and USB port of PC
User guide
49
Section 4.2
. The other steps are
002-39200 Rev. **
2023-12-11
Advertisement
Table of Contents
