Psoc™ 5Lp (Kitprog3) - Infineon TRAVEO T2G Cluster 4M Lite Kit User Manual

TRAVEO™ T2G Cluster 4M Lite Kit user guide
KIT_T2G_C-2D-4M_LITE
Hardware blocks
Table 4 shows the MCU device description.
Table 4 MCU device description
Reference
U200
Figure 16 shows the location of the CYT3DL device (MCU) in this kit.
Figure 16 CYT3DL device location
3.2 PSoC™ 5LP (KitProg3)
PSoC™ 5LP is a true programmable embedded system-on-chip, integrating configurable analog and digital
peripherals, memory, and a microcontroller on a single chip while the KitProg3 is low-level communication
firmware for programming and debugging. It provides communication between a programming tool (such as the
CYPRESS™ Programmer or PSoC™ Programmer) and a target, such as the PSoC™ 5LP. KitProg3 supports a variety
of development kits.
KitProg3 uses industry-standard Serial Wire Debug (SWD) and JTAG protocols, such as CMSIS-DAP V2.0.0 and
V1.2.0 as the Bulk and HID endpoint transport mechanisms. KitProg3 implements USB Bulk endpoints for faster
communication. It also supports HID endpoints for use cases that require them, but communication is slower.
KitProg3 also supports the following bridges: USB-UART, USB-I2C, USB-SPI, and GPIO. In this kit, the KitProg3 is
already configured to be used as a USB-UART bridge to program and debug the CYT3DL device.
Figure 17 shows the location of PSoC™ 5LP (KitProg3) in this kit.
User guide
Manufacturer
Infineon Technologies
20
Part number
CYT3DLBBHBES
Package, size
272- Ball BGA
002-39200 Rev. **
2023-12-11