Infineon TRAVEO T2G Cluster 4M Lite Kit User Manual page 51

TRAVEO™ T2G Cluster 4M Lite Kit user guide
KIT_T2G_C-2D-4M_LITE
Programming and debugging
Programming FX3 through control center
1. Before programming the FX3, make sure that you connect the jumper X502 on board, to enable FX3 to move
to Bootloader mode. Now press the FX3 Reset button (S500) on the board.
Figure 49 Shorting the jumper X502 and press reset button in TRAVEO™ T2G Cluster 4M Lite kit
2. Now connect the USB Type-C cable between the USB connector X500 on board and the USB port of your PC
(do not power the board with a 12-V DC adapter or USB Micro-B for programming FX3; the Type-C connector
is capable of powering it through USB port of your PC).
3. Open the search tab and search for "Control Center". If you cannot find it, go to Start > All apps > Cypress ,
and open it.
User guide 51 002-39200 Rev. **
2023-12-11