Crystal Oscillator; Reset Buttons - Infineon TRAVEO T2G Cluster 4M Lite Kit User Manual

TRAVEO™ T2G Cluster 4M Lite Kit user guide
KIT_T2G_C-2D-4M_LITE
Hardware blocks
3.9

Crystal oscillator

This kit supports two external clock sources: External Crystal Oscillator (ECO) and Watch Crystal Oscillator (WCO).
Figure 31 shows the location of the crystal oscillators in this kit.
Figure 31 ECO and WCO location
Note: The ECO gives a 16-MHz clock output while the WCO gives a 32.768-kHz clock output.
3.10

Reset buttons

There are two reset buttons and one reset jumper present on the board. The reset buttons are for the CYT3DL
device reset and FX3 reset. The X403 jumper is used to reset the on-board debugger KitProg3.
• S200 - MCU device reset
• S500 - FX3 reset
• X403 - KitProg3 reset
Figure 32 shows the locations of these reset buttons in this kit.
User guide 34 002-39200 Rev. **
2023-12-11