Programming And Debugging; Program Cyt3Dl Device Using Autoflashutility - Infineon TRAVEO T2G Cluster 4M Lite Kit User Manual

TRAVEO™ T2G Cluster 4M Lite Kit user guide
KIT_T2G_C-2D-4M_LITE

Programming and debugging

4 Programming and debugging
This section describes how to program and debug this kit. The FX3 programming steps are also described in this
section.
4.1

Program CYT3DL device using AutoFlashUtility

The AutoFlashUtility is a flexible, cross-platform, integrated application to allow programming Infineon devices.
It can perform Program, Erase, Verify, and Read operations on the target device flash. It can target an entire
device, a specific region, a sector, and even a byte of a device (contact
To use AutoFlashUtility tool in this kit, connect a micro-B cable between X400 and the USB port of the PC for using
the on-board debugger/programmer KitProg3. After that, run the commands from the command prompt to use
that AutoFlashUtility tool for flashing codes. The tool does not support debugging and should be used only for
programming.
Figure 38 shows the connection between USB micro-B X400 and the USB port of the PC to flash the code via the
AutoFlashUtility tool.
Figure 38 Connecting cable between X400 and PC for flashing via AutoFlashUtility
Note: Currently, we do not publish AutoFlashUtility on the web; contact
tool.
User guide
Technical Support
traveo@infineon.com
44
to obtain the tool).
if you need this
002-39200 Rev. **
2023-12-11