System And Functional Description; Getting Started - Infineon TRAVEO T2G Cluster 4M Lite Kit User Manual

TRAVEO™ T2G Cluster 4M Lite Kit user guide
KIT_T2G_C-2D-4M_LITE

System and functional description

2 System and functional description
This section explains how to set up and power up the TRAVEO™ T2G Cluster 4M Lite kit, and how to run the pre-
programmed firmware.
2.1

Getting started

2.1.1 Initial setup and default jumper connection
This section describes the default jumper configuration and location required for each module. Since some
interfaces are multiplexed, the default interface selection is mentioned in the following table.
This initial configuration also helps to generate all the power supplies from the PMIC and distribute them to safely
power-up the CYT3DL device.
Table 3 lists all the default jumper configurations.
Table 3 Jumper configurations
Jumper
X101
X102
X103
X104
X200
X201
X300
X301
X403
X502
X804
User guide
Function
3.3-V PMIC
1.1-V PMIC
12-V VIN selected
5-V VIN selected
12-V input
5-V input
VDDA selected to 3.3 V
VDDA selected to 5 V
VDDIO selected to 3.3 V
VDDIO selected to 5 V
KitProg RX
mikroBUS SPI CLK
KitProg TX
mikroBUS SPI MOSI
KitProg3 will not get reset
KitProg3 will get reset
FX3 not going into bootloader
FX3 will going into bootloader
VIN for Arduino header
VIN for Arduino header
9
Position: selection
1-2: short (default)
1-2: open
1-2: short (default)
1-2: open
1-2: short
2-3: short (default)
1-2: open
1-2: short (default)
1-2: short (default)
2-3: short
1-2: short (default)
2-3: short
1-2: short (default)
2-3: short
1-2: short (default)
2-3: short
1-2: open (default)
1-2: short
1-2: open (default)
1-2: short
1-2: short (default)
1-2: open
002-39200 Rev. **
2023-12-11