Infineon TRAVEO T2G Cluster 4M Lite Kit User Manual page 30

TRAVEO™ T2G Cluster 4M Lite Kit user guide
KIT_T2G_C-2D-4M_LITE
Hardware blocks
Figure 27 Connection required to stream FX3 into PC
Note: If you want to program the EZ-USB™ FX3, connect the jumper X502 (highlighted in
board. Ensure that you connect and disconnect the power again in the lite kit after this jumper
configuration.
Note: If you want to stream the graphics output via EZ-USB™ FX3, remove the jumper X502 (highlighted in
Figure 27) from the board.
User guide 30
Figure 27) on the
002-39200 Rev. **
2023-12-11