Infineon TDA7210V Quick Start Manual

Read Me First
TDA7210V Remote Control Rx-Board
Design Example by Mipot S.p.A.
Dear Customer,
Thank you for working with Infineon Wireless Control products!
This TDA7210V Remote Control Receiver-Board represents a typical design example
how the TDA7210V can be used as a receiving component in a remote control
application. On the side of the TDA7210V there is a microcontroller decoding the
received signal and driving the five output channels. This design is fully compatible to
Infineon's PMAfob remote control transmitter (see www.infineon.com/PMAfob).
All design information is available for download on the Infineon internet pages
(see www.infineon.com/TDA7210V):
Schematic
PCB layout
Components list
Microcontroller firmware (C source code)
The TDA7210V Remote Control Rx-Board was designed by one of Infineon's
recommended design houses for Wireless Control products:
Mipot S.p.A. (www.mipot.com)
For further support please contact your local Infineon Distributor, your responsible
Infineon Sales Office, contact us directly at wirelesscontrol@infineon.com or call us
at 0(0)800 951 951 951. This is an international toll free phone number. In case this
service is not supported in your country, you can find a complete list of Infineon
service phone numbers at www.infineon.com/customercarecenter.
Please, don't forget to take notice of the legal disclaimer sheet.
We wish your development work using Infineon's Wireless Control products will be
successful.
Your Infineon Wireless Control Team
www.infineon.com/TDA7210V www.infineon.com/PMAfob
K it C o n t e n t
TDA7210V Remote Control Rx-Board
PMAfob Remote Control Transmitter
1 antenna, ¼ lambda - reduced size
Legal disclaimer sheet
Firmware source code and Hardware
design documentation available
for download at
www.infineon.com/TDA7210V
TDA7210V_RC_RxBoard_vx.y.zip
Other available PMAfob demos:
PMAfob RKE demonstrator
PMAfob Home Automation
demonstrator
September 2010