Table of Contents
Advertisement
TRAVEO™ T2G Cluster 4M Lite Kit user guide
KIT_T2G_C-2D-4M_LITE
Programming and debugging
4.2
Program and debug CYT3DL device using IAR Embedded Workbench
This kit supports the programming and debugging using the third-party software and hardware like IAR-EWARM
(embedded workbench for Arm® software and I-Jet debugger) and Green Hills System (Multi IDE software and
GHS probe debugger).
Download the latest Sample Driver Library (SDL) for the TRAVEO™ T2G Cluster 4M Lite kit in the PC. Install the SDL
outside the default program files to allow the IDE to access and create temporary files.
Open the Readme.pdf from the root folder of the SDL and use the same link to download the version of IAR EWARM
supported by the SDL. Download the software and run the installation (note that the installation might take some
time).
When you open the IAR EWARM for the first time, select the license in the License wizard. If you do not have the
license, it is strongly recommended to register for a code size limited license type. After downloading and setting-
up the IDE, extract the folder available in the following path: SDL (version 7.9.0 or higher) -> misc. -> tools ->iar ->
IAR_EWARM_9301_FlashLoader_Patch_TraveoII.zip , and follow the readme.txt document available there for patch
files copying to support SDL and the device with that IDE.
The CYT3DL device is now ready to program and debug by connecting the I-Jet debugger with
Arm20 adapter
to the X302 jumper on the board. Refer to
flashing through the KitProg3 USB-UART bridge.
There are two debugging methods with IAR EWARM:
1. Debugging with download on the RAM.
2. Debugging with download on the Flash (described in this document).
Follow these steps to download and debug using the CM0+ core workspace:
1. Start IAR EWARM 9.32.1 and go to "file\open workspace", and then select the following path:
T2G_Sample_Driver_Library_7.9.0\ tviic2d4m\ tools\ iar\ flash\ tviic2dd4m_flash_cm0plus_template.
Figure 39
Opening workspace in IAR EWARM
User guide
Section 4.3
to use the Micro-B cable to X400 with
45
i-Jet MIPI20 -
002-39200 Rev. **
2023-12-11
Advertisement
Table of Contents
