Powering-Up The Lite Kit - Infineon TRAVEO T2G Cluster 4M Lite Kit User Manual

TRAVEO™ T2G Cluster 4M Lite Kit user guide
KIT_T2G_C-2D-4M_LITE
System and functional description
Table 3 Jumper configurations (continued)
Jumper
X808
X809
X810
X811
2.2

Powering-up the lite kit

The TRAVEO™ T2G Cluster 4M Lite kit can be powered through any of these three options:
• USB type-C (default powering option)
• 12-V DC power adapter
• USB micro-B (KitProg3 also gets powered-up here)
2.2.1 USB Type-C
Change the jumper positions as follows (highlighted with a yellow box in
• X103 - short 2-3
• X104 - short.
Now, connect the Type-C cable between the USB Type-C connector X500 and the USB Type-C port of the
laptop/PC. Once this jumper configuration is done, observe that the power LEDs (3.3 V, 1.2 V, and 1.1 V) start
glowing.
Figure 3 shows the connection of the USB Type-C cable and jumper configuration.
User guide
Function
3.3 V for RPi header
No 3.3 V to RPi header
TDM RX FSYNC going to RPi header
TDM RX FSYNC to TX FSYNC
TDM RX MCLK going to RPi header
TDM RX MCLK to TX MCLK
TDM RX SCK routed to RPi header
TDM RX SCK to TX SCK
10
Position: selection
1-2: short (default)
1-2: open
1-2: short
2-3: short (default)
1-2: short
2-3: short (default)
1-2: short
2-3: short (default)
Figure 3):
002-39200 Rev. **
2023-12-11