Program And Debug Interface - Infineon TRAVEO T2G Cluster 4M Lite Kit User Manual

TRAVEO™ T2G Cluster 4M Lite Kit user guide
KIT_T2G_C-2D-4M_LITE
Hardware blocks
Figure 21 PMIC and LDO location
3.5

Program and debug interface

This kit has an Arm® Standard 20-pin JTAG connector to program and debug the CYT3DL device. Additionally, you
can use the on-board debugger KitProg3 to program and debug the CYT3DL device.
You can use the GHS Probe directly to program and debug the kit by connecting it to the X302 connector. You can
also use the JTAG-to-20-pin Arm® converter
connector to program and debug it with the I-jet debugger.
3.5.1 KitProg3 programming interface
KitProg3 uses the industry-standard SWD protocols, such as CMSIS-DAP V2.0.0 and V1.2.0 as the bulk and HID
endpoint transport mechanisms.
The KitProg USB-UART bridge helps you to program and debug the CYT3DL device just by connecting the Micro-
B cable between the USB X400 Micro connector and the USB port of the PC. Refer to
Figure 22 shows how to connect this kit with the PC for programming and debugging through KitProg3.
User guide
(I-jet MIPI20 - Arm20 adapter) to connect the I-jet with the X302
25
Section 4 for more details.
002-39200 Rev. **
2023-12-11