Infineon TRAVEO T2G Cluster 4M Lite Kit User Manual page 47

TRAVEO™ T2G Cluster 4M Lite Kit user guide
KIT_T2G_C-2D-4M_LITE
Programming and debugging
4. For checking the debugger option, right-click on the "cm0plus - lite_kit" and select "Options", and then
"Debugger". Check what is selected in the driver menu in the Debugger tab. If you are using the I-JET
debugger, then select "I-jet" or if you are using the KitProg USB-UART bridge, then you can use the "CMSIS
DAP" option there. Since this example uses the I-jet debugger, select the "I-jet" option and press OK .
Figure 42 Checking the debugger option in IAR
5. For the build, right-click on the "cm0plus - lite_kit" and select the "Rebuild All" option.
Figure 43 Compiling and building the code in IAR
User guide 47 002-39200 Rev. **
2023-12-11