Table of Contents
Advertisement
TRAVEO™ T2G Cluster 4M Lite Kit user guide
KIT_T2G_C-2D-4M_LITE
Programming and debugging
Attention: If you have connected the X502 jumper on your board, then note the device "Cypress FX3 USB Boot
Programmer Device" under the "Universal Serial Bus controllers" tab in the Device Manager, as
shown in
Figure
Figure 54
EZ-USB™ FX3 coming under Universal Serial Bus Controllers
Attention: If you removed the X502 jumper from your board, note the "FX3" device under "Camera" in the
Device Manager, as shown in
connect the power in the kit again to see them in the device manager under these tabs.
Figure 55
EZ-USB™ FX3 coming under Camera in Device Manager
User guide
54.
Figure
55. Before or after removing the X502 jumper, disconnect and
54
002-39200 Rev. **
2023-12-11
Advertisement
Table of Contents
