Advertisement
Quick Links
Advertisement
Related Manuals for Infineon TLE9562
Summary of Contents for Infineon TLE9562
- Page 1 Quick-start of the TLE9562 shield with the uIO stick 2022-02-24 restricted...
- Page 2 › Connect the uIO stick to the shield and to the PC › Enable the 12V supply – The green LED should be on 2021-02-08 restricted Copyright © Infineon Technologies AG 2021. All rights reserved.
- Page 3 Start the Config Wizard for the motor system IC and start › The GUI should look like that: showing the that uIO stick communicate with the TLE9562 For example the charge pump is disabled 2021-02-08 restricted Copyright © Infineon Technologies AG 2021. All rights reserved.
- Page 4 Step 3 › Clear failures (if any) 2021-02-08 restricted Copyright © Infineon Technologies AG 2021. All rights reserved.
- Page 5 Step 3 › Load the file: – File Load – A pop-up window appears Discard – Browse and select the file TLE9562_ConfigWizard_2020_06_25_1.icwp (unzip the file before) 2021-02-08 restricted Copyright © Infineon Technologies AG 2021. All rights reserved.
- Page 6 Step 3 › The pre-settings are loaded into the TLE9562, for example, the charge pump is enabled, the half- bridge 1 is set in PWM, the charge and discharge currents and timings for the gate drivers are configured 2021-02-08 restricted...
- Page 7 Step 4 – Activate the motor connected between OUT1 and OUT2 › Enable the PWM1 generator by the uIO stick and applied to the PWM1 pin of the TLE9562, set the duty cycle › Turn on the low-side 1 (PWM MOSFET) ›...