TRAVEO™ T2G Cluster 4M Lite Kit user guide
KIT_T2G_C-2D-4M_LITE
Programming and debugging
5. Now, you will be prompted for the location of the UVC image to flash into FX3. Locate the directory that has
the image file which you want to program. After selecting that image in the bottom left of the Control Center,
note the status of the flashing.
Figure 52
Flashing UVC image into FX3
6. If the status shows "Programming of I2C EEPROM Succeeded", the FX3 is programmed. You can close the
Control Center tab now and remove the X502 jumper from the kit.
Figure 53
Programming of FX3 is done
User guide
53
002-39200 Rev. **
2023-12-11