TRAVEO™ T2G Cluster 4M Lite Kit user guide
KIT_T2G_C-2D-4M_LITE
The board at a glance
1.2
Block diagram
This section shows the TRAVEO™ T2G Cluster 4M Lite block diagram.
Z
Z
s
W
Figure 2
Block diagram
Note:
The block diagram contains only the major interfaces; there may be extra blocks between the CYT3DL
device and the peripheral component block.
1.3
Main features
•
TRAVEO™ T2G CYT3DL device (MCU)
•
EZ-USB™ FX3 device
•
PSoC™ 5LP (KitProg3) for program and debug
•
Crystals
– 16-MHz external crystal oscillator (ECO)
– 32.768-kHz watch crystal oscillator (WCO)
•
Serial Memory Interface (SMIF)
– SEMPER™ Flash (S26HL)
– HYPERRAM™ (S27KL)
•
Raspberry Pi compatible I/O header (also compatible with Audio HAT for Audio-codec)
•
Arduino-compatible header (also compatible with CY8CKIT-026 for CAN and LIN)
•
mikroBUS™ header and Shield2Go footprints
•
Single-channel FPD-Link/LVDS interface for up to 1920 x 720 video output
•
MIPI-CSI2 camera connector
•
PMOD connector to support external ethernet PHY (also supports DP83848 Ethernet board)
•
Arm® Standard 20-pin JTAG header for program and debug
•
Human interface
User guide
W
W
, d
h^ D
W
< W
W^
h^
h^
dD
&y
h^ d
W
E >/E
/
^
'
/
^
'
zds//
D
^DWZ &
&W >
,zWZZ D
&W >
6
:d '
'
WDK
d,
D/W/
002-39200 Rev. **
W
d, W,z
D/W/
2023-12-11