LEMKEN Saphir 7-B AutoLoad Operating Instructions Manual page 14

Maintenance
• Repair-, maintenance- and cleaning operations as well as adjustments
and remedy of function faults should principally be conducted with engine
stopped and brakes applied. Remove ignition key!
• Check and tighten nuts and bolts regularly!
• When conducting maintenance work on a lifted implement always place
suitable supports underneath!
• For replacing any tools with cutting edges always use suitable tools and
gloves!
• Dispose of old oils, grease and filters as prescribed by law.
• Before working on the electric gear disconnect battery cables!
• When conducting electrical welding operations on the tractor or on the
mounted implement remove cable from the generator and the battery!
• Any spare parts fitted must meet with the implement manufacturer's fixed
technical standards! This is for example ensured by using genuine spare
parts!
Seed drills
• During the calibration test watch out for rotating or oscillating parts of the
implement!
• Use only steps for filling. It is not allowed to travel on the steps during ope-
ration!
• When filling the hopper adhere to the instructions of the manufacturer!
• Lock track markers in transport position!
• Never place any parts inside the hopper as the agitator shaft rotates, even
during preparation work e.g. calibration!
• Never exceed the maximum allowed filling quantity!
12