LEMKEN Saphir 7-B AutoLoad Operating Instructions Manual page 13

• There is the risk of injury from pinch and shear points in the three-point lin-
kage area!
• When operating the external lift controls for the three-point linkage, do not
stand between the tractor and implement!
• Always ensure sufficient lateral limitation for the three-point linkage of the
tractor in the transport position of the implement!
• When driving on roads with the implement raised, the raise/lower control
must be locked to prevent lowering!
Hydraulic equipment
• The hydraulic pipes are under pressure!
• When connecting hydraulic rams, the pipes must be connected as direc-
ted!
• Always release hydraulic pressure from both tractor and implement before
coupling!
• When connecting hydraulic pipes to the tractor ensure that incorrect use is
avoided. If the connections are reversed, the opposite function is carried
out (e.g. raising/lowering) and there is a risk of accidents!
• Regularly check the hydraulic pipes and replace them in the event of da-
mage or signs of ageing. The replacement pipes must comply with the
technical specification as laid down by Lemken!
• When searching for leaks appropriate equipment should be used because
of the danger of injury!
• Hydraulic oil escaping at high pressure can penetrate the skin and cause
serious injury! When injured see a doctor immediately! Danger of infection!
• Before working on any hydraulic equipment - lower all implements/attach-
ments, release hydraulic pressure where possible and switch off the trac-
tor engine!
11