LEMKEN Saphir 7-B AutoLoad Operating Instructions Manual page 12

• Adhere to the maximum permissible axle loads, total weights and transport
width!
• Fit and check transport gear, road lights and warning guards!
• The release ropes for quick coupler latches should hang freely and in the
lowered position must not release the quick coupling by themselves.
• Never leave the driver's seat whilst in motion!
• Handling behaviour, steerability and braking are influenced by mounted
implements, trailers and ballast weights. Check for sufficient steerability
and braking!
• When driving round bends note the width of the machine and/or changing
centre of gravity of the implement.
• Put implement into operation only when all guards are fixed in position!
• Never stay or allow anyone to stay within the operating area!
• Never stay in the turning and slew area of the implement!
• Do not operate any hydraulic controls while anybody is in the operating
area!
• On all pivoting parts actuated by power assistance (e.g. hydraulics) exists
danger of injury by bruising and crushing!
• Before leaving the tractor lower the machine to the ground. Apply the par-
king brake, stop the engine and remove the ignition key!
• Do not allow anybody between the tractor and implement if the parking
brakes are not applied!
Attached implements
• Before mounting or dismounting implements on/from the three-point linka-
ge, move the raise / lower control to the position at which accidental raising
or lowering cannot take place!
• In the case of three-point linkage mounting, ensure that the tractor balls
and the mounting pins of the implement are of the same category!
10