Riello NXHP Series Installation, Operation And Maintenance Instructions page 46

3 - INSTALLATION OF SYSTEM
b- Manage the Master unit and Slave units with a common user interface
Thanks to common user interface on the master unit, it is possible to access data of slaves (main screen, parameter menu...).
The procedure to navigate between the different general status of units and pass from Master to Slave 1, then to Slave 2 (if existing),
then to Slave 3 (if existing), is the following:
To navigate from Master to Slave or Slave to Salve, press and hold the Occupancy key and Up key simultaneously for 2 seconds.
Figure 17: WUI screen for Slave 1
From this screen, it is possible to access all data of Slave 1 (parameter menu...).
To finish the commissioning, it is necessary to configure setpoint according to the user interface configuration
46