Table of Contents
Advertisement
Setup Procedures
Key Operator Tools
Machine Setups
Fault Override
Page 11-2
During manufacture, certain settings for features and functions
of the DC440/432/430/426/425/420 are programmed into the
machine. Once the machine is installed, the Setup Tools can
be used to change these settings to suit the user's
environment.
To change the settings, a user enters a PIN (Personal
Identification Number). Depending on the access rights
assigned to the PIN, any or all of the following tools can be
accessed to allow the various settings to be changed.
NOTE: It is recommended that Setups should not be
accessed until the machine has completed its power on
sequence.
For further information about assigning PINs, refer to "Access
Rights" on page 11-86.
If a PIN is entered that has been assigned 'Key Operator'
access rights, the user can set up or change the machine and
feature settings. These include some or all of the following,
dependent on machine configuration.
enable machine specific default settings to be changed or set
up, including paper tray defaults, machine date and time
settings, the touch screen display, machine timers and reports.
For further information refer to "Machine Setups" on page 11-6.
is used to disable a faulty component so that other components
and features may still be used.
For further information refer to "Fault Override" on page 11-19.
Copy Setups
enable the Copy specific default settings to be changed or set
up.
Refer to "Copy Setups" on page 11-25 for further information.
Xerox Document Centre 440/432/430/426/425/420 User Guide
Advertisement
Table of Contents
